Decoder installation on BR 132/232 (Trix) for N (1:160)

Used decoder is with 80mm long wires, Fleischmann 685402, without sound, NEM651 (6 pins).

Required time approximately 30 minutes for installation.

So here is the Beauty V132/ 232, N (1:160)

1. Removing (desoldering) all analog components - two diodes, coil and condenser,located on the underside of the board. Desoldering and wires on the underside of thehull, which transferred power on board (mine was green, which is then used for other).Without removing the board of the locomotive will not go. I regret that this time Imissed it with the camera.

2. Put an insulating tube between the poles of the engine (right brush), which takespower from the hull.

3. Put tape or double sided adhesive tape at the top of the locomotive (right is the leading cab) to prevent the decoder, but after the completion of work second one should be put on top. Double adhesive is better because it provides ventilation of the decoder.

4. Green wire from the power is soldering it to the motor terminals on one side , which has been isolated, and to the upper part of board on other side. On same bus on the other side soldering the orange wire from the decoder.

5. White wire for forward lights, yellow wire for backword lights, Orange wire - right brush, Gray wire- left brush, Red wire - rail 1, black- rail 2. In the case of the black wire is passed through the hole on the board along the engine pull out of underside of the hull, which was previously green wire.

6. Put on the decoder fixation (isolates that do not allow him to move to avoid shortcut circuit). I have covered only half the decoder).