Decoder installation on V60/260/360 for N (1:160)

Locomotive: Hobbytrain V 60/260/360 in N
Decoder: Flieschmann без звук по NEM651 (6 pins)
Digital format: DCC
Interface: Yes
Milling: No

I start putting the decoder prepared with NEM651 interface locomotive, which did notcatch faith and do additional processing to calm my soul.

1. Open model

2. Get out plugs

... ad view to the decoder place

3. Put insulation (included in the decoder set) on chassis under the decoder ...in case

4. This should be completed by placing the decoder ...

..Foduring testing, however, felt slight doubt in his work and I began view the board to seethe components and circuits which are closed ....

And I decided to try to eliminate the two coils and capacitors (SMD assembly) and to try. desolder coils in place to link to the plug wires and spearing the engine directlythere .. the result was perfect. The little bee buzzing on the tracks...

5. Remove final coils (with soldering).

Solder wires from the engine ... It should be noted that the color scheme of the cables is severely smeared by the manufacturer ....
Black and gray are the power wires, and Orange (yellow in the picture because itchanged) and red for the engine.
In case the picture is red tie instead of gray (from decoder), and yellow instead oforange.
Because the motor cables are short .. one spliced ​​it (red) and insulated with tape onthe contradictory sets of decoder ... now I wonder why after I replaced the orangewith yellow and red not changed, but sometimes it takes time to figure mistakes.

Try the cables to pass away, because the lid fits on the engine ... found that aftertaking a picture, while trying to assemble, but you can see photos of items 1, wherethe model is just open.

And our bee goes to the battlefield